Why is my bobbin thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. … In this case, it might be necessary to loosen both the bobbin tension AND the top tension.
Why is my bottom bobbin not catching?
First, your needle may be dull or damaged and needs to be replaced. You should also check that you are using the correct needle for the type of fabric you are sewing. … If the needle is not inserted correctly, it will not be able to pull up the bobbin thread and will cause skipped stitches.
Why does bobbin thread keep jamming?
Make sure your bobbin thread is wound evenly on the bobbin. If the thread is wound uneven make sure the bobbin thread is through the bobbin thread winding thread guide when you start to wind your bobbin. … If the bobbin case has been inserted incorrectly into the outer rotary hook your machine will jam.
Why does my sewing machine keep jamming underneath?
The reason for the problem could be lint, dust and other debris getting stuck in their mechanism. The solution: Stop work, lift the presser foot and thoroughly clean the fee dogs from any debris. Also, make sure that they are lifted up in a raised position allowing for a proper grip of the fabric.
How do I know if my bobbin tension is correct?
The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.
What are the common sewing machine troubles?
Common Sewing Problems
- Needle thread breakage.
- Bobbin or looper thread breakage.
- Thread fusing when the machine stops.
- Skipped stitches.
- Imbalanced / variable stitching.
- Staggered stitching.
- Variable stitch density.
- Seam pucker.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.